Table of Contents
Advertisement
USING SETUP MODE
5-72
3. Print the hex dump.
To start hex dump printing, send your file or program to the
printer. The printer goes online and prints the hex dump.
Press the LOAD button to pause during hex dump printing. To
resume hex dump printing, press the "LOAD" button again.
NOTE
When hex dump printing stops, data that is less than one
line printed yet, to print remaining data exit Hex-Dump
mode(push LF/FF or ONLINE).
4. Exit the HEX-DUMP function.
Exit the HEX-DUMP function in either of the following ways:
•
To remain in setup mode, press the LF/FF button. The
<<FUNCTION>> menu is then reprinted (LED type). For
details on other functions, see other sections in this chapter.
•
To return to online normal mode, press the ONLINE button.
If you press the ONLINE button while the hex dump is
printing, the printer immediately switches to normal online
mode, but data that was sent to the printer is printed in
normal mode. At same time the printer permanently saves
any changes made while in setup mode.
You can also enter hex dump mode, by turning off the printer, and then
turning the printer back on while simultaneously pressing the ONLINE
button and the LF/FF button until the printer beeps.
Sample hex dump
User's Manual
Advertisement
Table of Contents
