Fujitsu DL7600Pro User Manual page 156

USING SETUP MODE
5-52
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Options
Items
<FCNTARE>
ENABLE1
ENABLE2
DISABLE
<RCNTARE>
ENABLE1
ENABLE2
DISABLE
Description
Area-over detection control of front
continuous forms.
Detects the left and right edges of
paper when loading the paper.
Detects the left and right edges of
paper at 13mm and 43mm from top
of the paper. This setting is
effective if the left and right edges
are not detected by <ENABLE1>
for preprint papers, etc.
Does not detect the edges. Select
this option when you are using
colored or preprinted paper.
Area-over detection control of rear
continuous forms.
Detects the left and right edges of
paper when loading the paper.
Detects the left and right edges of
paper at 13mm and 43mm from top
of the paper. This setting is
effective if the left and right edges
are not detected by <ENABLE1>
for preprint papers, etc.
Does not detect the edges. Select
this option when you are using
colored or preprinted paper.
User's Manual