Fujitsu DL7600Pro User Manual page 174

USING SETUP MODE
5-70
2. Select the SELF-TST function.(LED)
Repeatedly press the "TEAR OFF" or "LOAD" button to
position the cursor on the left edge of the aluminum print guide
on SELF-TST, and then press the "" button or the "" button.
The printer selects SELF-TST and starts printing. A short help
menu is printed at the top of the page, followed by the self-test.
Note that the printer is not online during self-test printing.
1. Move to TOP MENU of SETUP MODE.(LCD)
Press the "" button until "SETUPMODE" is displayed on
LCD panel.
2. Select the SELF-TST function.(LCD)
Repeatedly press the "" or "" button to display
"SELFDIAGNOSTIC". And then press the"" button to move
lower layer. And then repeatedly press the "" or "" button to
display "SELF-TEST". And then press the "SELECT" button to
start self-test printing. A short help menu is printed at the top of
the page, followed by the self-test. Note that the printer is not
online during self-test printing.
3. Examine the self-test page.
A sample self-test page is shown in Chapter 2. To pause during
self-test printing, press the "LOAD" button. To resume self-test
printing, press the "LOAD" button again.
4. Exit the SELF-TST function.
Exit the SELF-TST function in either of the following ways:
• To exit SELF-TST and remain in setup mode, press the
LF/FF button. The <<FUNCTION>> menu is then
reprinted (LED type).
To exit SELF-TST and return online, press the ONLINE
•
button. The printer permanently saves any changes made
while in setup mode and returns online.
The self-test can also be started by turning off the printer, and then
pressing the LF/FF button while turning the printer back on. As
described in Chapter 2, this method is useful when you first set up the
printer.
User's Manual