Fujitsu DL7600Pro User Manual page 148

USING SETUP MODE
5-44
Table 5.6 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST Options
Items
<CNT-LFT>
-10/90, ..., 0/90,
..., 10/90
<CUT-LFT>
-10/90, ..., 0/90,
..., 10/90
<FCNTADJ> -14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
<RCNTADJ> -14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
<FCNTAJL> -14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
Description
Fine-tunes the left print start position
for continuous forms.
Moves the position left or right in
increments of 1/90 inch
(0.28 mm).
NOTE:
This setting is effective only at
< RCNT-SF: DISABLE > when the
back tractor is used.
< FCNT-SF: DISABLE > when the
front tractor is used.
Fine-tunes the left print start position
for single sheets.
Moves the position left or right in
increments of 1/90 inch
(0.28 mm).
NOTE:
This setting is effective only at < CUT-
SF:DISABLE >.
Compensates for the forms feed error
accumulated through feeding of front
continuous forms.
Compensates for the forms feed error
accumulated through feeding of rear
continuous forms.
Compensates for the forms feed error
accumulated through feeding of front
continuous forms. (Last page)
User's Manual