Installing The Superworkstation 7043A-8R/7043A-I Into A Rack - Supero SuperWorkstation 7043A-8R User Manual

S W
UPER ORKSTATION 7043A-8R/7043A-i Manual
2-4 Installing the 7043A-8R/7043A-i into a Rack
This section provides information on installing the SuperWorkstation 7043A-
8R/7043A-i into a rack unit.
mounted into a rack or if you are using it as a tower, you can skip ahead to
Sections 2-5 and 2-6.
which may mean the assembly procedure will differ slightly. The following
is a guideline for installing the 7043A-8R/7043A-i into a rack with the rack
rails provided in the rackmount kit. You should also refer to the installation
instructions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails:
The 7043A-8R/7043A-i rackmount kit (CSE-PT26 or CSE-PT26B - black) in-
cludes two rack rail assemblies. Each of these assemblies consist of three
sections: an inner fixed chassis rail that secures to the 7043A-8R/7043A-i
(A), an outer fixed rack rail that secures directly to the rack itself (B) and a
sliding rail guide sandwiched between the two, which should remain at-
tached to the fixed rack rail (see Figure 2-1.) The A and B rails must be
detached from each other to install. Two chassis handles are also included
with the rail kit.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Depress the locking tab to pull the
inner rail completely out. Do this for both assemblies.
A
Figure 2-1.
If the 7043A-8R/7043A-i has already been
There are a variety of rack units on the market,
B
Identifying the Sections of the Rack Rails
2-4