Glan Enable/Disable; Power Fail Alarm Enable/Disable; Cpu Chassis/Cpu Fan Select - Supero SuperWorkstation 7043A-8R User Manual

GLAN Enable/Disable

Change the setting of jumper JD4
to enable or disable the onboard
GLAN port on the motherboard.
See the table on the right for
jumper settings.
ting is enabled.
Power Fail Alarm Enable/
Disable
The system can notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup. If you only have one or
two power supply units installed,
you should disable this (the default
setting) with JP9 to prevent false
alarms. See the table on the right
for jumper settings.
setting is disabled.
will not function on the 7043A-i.
CPU Chassis/CPU Fan
Select
JP33 allows you to select which fan
speed to have displayed in the
Hardware Monitors section of BIOS
(the CPU1/2 fans or the CPU1/CPU2
Chassis fans). The default position
is closed to select the CPU fan.
See the table on the right for jumper
settings.
Chapter 5: Advanced Motherboard Setup
The default set-
The default
This feature
5-19
GLAN
Enable/Disable
Jumper Settings
(JD4)
Jum per
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Power Fail Alarm
Enable/Disable
Jumper Settings (JP9)
Jumper
Position Definition
Open Disabled
Closed Enabled
CPU CHassis/CPU Fan
Select Jumper Settings
(JP33)
Jumper
Position Definition
Open CPU Chassis
Closed CPUFan