Installing The 6023P-8R/6023P-8 Into A Rack; Identifying The Sections Of The Rack Rails - Supero SUPERSERVER 6023P-8R User Manual

Chapter 2: Server Installation
2-4

Installing the 6023P-8R/6023P-8 into a Rack

This section provides information on installing the SuperServer 6023P-8R/
6023P-8 into a rack unit. If the 6023P-8R/6023P-8 has already been
mounted into a rack, you can skip ahead to Sections 2-5 and 2-6. There
are a variety of rack units on the market, which may mean the assembly
procedure will differ slightly. The following is a guideline for installing the
6023P-8R/6023P-8 into a rack with the rack rails provided. You should
also refer to the installation instructions that came with the rack unit you
are using.

Identifying the Sections of the Rack Rails:

You should have received two rack rail assemblies with the SuperServer
6023P-8R/6023P-8. Each of these assemblies consist of three sections: an
inner fixed chassis rail that secures to the 6023P-8R/6023P-8 (A) and an
outer fixed rack rail that secures directly to the rack itself (B). A sliding rail
guide sandwiched between the two should remain attached to the fixed
rack rail. (See Figure 2-1.) The A and B rails must be detached from each
other to install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull
the inner rail completely out. Do this for both the left and right side rack
rail assemblies.
A
B
Figure 2-1. Identifying the Sections of the Rack Rails
2-3