Midea MFEP26VA-N User Manual page 42

Handling the Remote Controller
Inserting and Replacing Batteries
Your air conditioning unit may come with two
batteries(some units). Put the batteries in the
remote control before use.
1. Slide the back cover from the remote control
downward, exposing the battery compartment.
2.
Insert the batteries, paying attention to match
up the (+) and (-) ends of the batteries with
the symbols inside the battery compartment.
3.
Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
Do not mix old and new batteries, or
•
batteries of di erent types.
Do not leave batteries in the remote
•
control if you don't plan on using the
device for more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for
proper disposal of batteries.
TIPS FOR USING REMOTE CONTROL
The remote control must be used within 8
•
meters of the unit.
The unit will beep when remote signal is
•
received.
Curtains, other materials and direct sunlight
•
can interfere with the infrared signal
receiver.
Remove batteries if the remote will not be
•
used more than 2 months.
NOTES FOR USING REMOTE CONTROL
The device could comply with the local national
regulations.
In Canada, it should comply with
•
CAN ICES-3(B)/NMB-3(B).
In USA, this device complies with part 15 of
•
the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception,which can be determined by turning
the equipment o and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the
•
equipment and receiver.
• Connect the equipment into an outlet on a
circuit di erent from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
Changes or modifications not approved by the
•
party responsible for compliance could void
user's authority to operate the equipment.
40