Midea MFEP26VA-N User Manual page 19

1. Open and fix the position of the panel,
then, open the covers of the two lock
blocks, remove the screw , then hold
both sides of the lower panel in the place
marked "PULL", pull it upwards to release
the buckles, then take the lower panel
down(please refer to Page 14).
2. Open the wire box cover on the right side
of the unit. This will reveal the terminal block.
3. Unscrew the cable clamp below the terminal
block and place it to the side.
4. Facing the back of the unit, remove the plastic
panel on the bottom left-hand side.
5. Feed the signal wire through this slot, from
the back of the unit to the front.
6. Facing the front of the unit, connect the wire
according to the indoor unit's wiring diagram,
connect the u-lug and firmly screw each wire
to its corresponding terminal.
7. After checking to make sure every connection
is secure, use the cable clamp to fasten the
signal cable to the unit. Screw the cable clamp
down tightly.
8. Replace the wire cover on the front of the
unit, and the plastic panel on the back.
In North America
NOTE: Choose the cable type according to the
local electrical codes and regulations. Please
choose the right cable size according to the
Minimum Circuit Ampacity indicated on the
nameplate of the unit.
First open the front panel, then remove
the lower panel.
Rat ba e(some units)
Knock-out
panel
NOTE: If the size of the cable is too big,
remove the middle small plastic knock-out
panel to create a slot through which the cable
can exit. If you want to remove the chassis or
drain hose, please remove the rat ba e first.
NOTE: For North America products, first
remove the knok-out panel to create a slot
through which the conduit tube can install.
Then make the cable through the conduit
tube and connect to the indoor unit.
17
open the
Wire cover
Terminal
block
Cable
clamp