Midea MFEP26VA-N User Manual page 14

CAUTION
When drilling the wall hole, make sure to avoid wires, plumbing, and other
sensitive components.
Drill wall hole
(2-1/2")
Using a 65mm (2-1/2") or 90mm(3-9/16")
core drill(depending on models )
Indoor
Drill the wall hole
Place the protective wall cu in the hole.
NOTE : FOR CONCRETE OR BRICK WALLS
If the wall is made of brick, concrete, or similar material, drill 5mm-diameter (0.2in-diameter) holes in
the wall and insert the sleeve anchors provided. Then secure the mounting plate to the wall by
tightening the screws directly into the clip anchors.
65mm
Wall
Outdoor
Fig.3.2
the protective
wall hole.
90mm
(3-9/16")
Step 1：
Using a 65mm (2.5") or 90mm(3.54")
core drill(depending on models ), drill a
hole in the wall. Make sure that the hole
is drilled at a slight downward angle, so
that the outdoor end of the hole is lower
than the indoor end by about 5mm to
7mm (3/16-5/16"). This will ensure
proper water drainage.
wall cu
Step 2：
Place the protective wall cu in the hole.
This protects the edges of the hole and
will help seal it when you finish the
installation process.
12