Midea MFEP26VA-N User Manual page 16

If refrigerant piping is already embedded in the wall, do the following:
30-50mm
（1-3/16~2in）
Move to left or right
Model A
Open the cover
and unscrew the
screws
Unscrew the
screws
Model B
Use the holder at the back
of the unit against on the
mounting plate to prop up
the unit
30-50mm
Keep in mind that the hooks on the mounting plate are
（1-3/16~2in）
smaller than the holes on the back of the unit.
If you find that you don't have ample room to connect
embedded pipes to the indoor unit, the unit can be
adjusted left or right by about 30-50mm (1.18-1.96in),
depending on the model.
Open the cover
and unscrew the
screw
●
●
●
●
●
●
●
NOTE : UNIT IS ADJUSTABLE
Open and fix the position of the panel, then, open the
covers of the two lock blocks, unscrew the screw
showed in the picture (Model A & Model B), then hold
both sides of the lower panel in the place marked
"PULL", pull it upwards to release the buckles, then
take the lower panel down.
Use the holder at the back of the unit to
prop up the unit, giving you enough room
to connect the refrigerant piping, signal cable,
and drain hose.
Connect drain hose and refrigerant piping (refer to
Refrigerant Piping Connection section of this manual
for instructions).
Keep pipe connection point exposed to perform the
leak test (refer to Electrical Checks and Leak Checks
section of this manual).
After the leak test, wrap the connection point with
insulation tape.
Release the holder that is propping up the unit.
Using even pressure, push down on the bottom half
of the unit. Keep pushing down until the unit snaps
onto the hooks along the bottom of the mounting
plate.
14