Assembly From Truck Shipment - Schulte GX-130 Operator's Manual

ASSEMBLY

Assembly from Truck Shipment

The following are instructions to set up a GX-130
cutter that has been delivered on a truck.
When the cutter is received the hitch will be
flipped back onto the cutter as shown on Figure
AsmP-R-0571. The hitch must be flipped down
into working position and pinned to the tension
link. Care should be taken when flipping the hitch
down as it is heavy and will want to fall when it
over centers so a lifting device should be used.
Line up the tension link and the hitch as shown in
Figure AsmP-R-0125. Use the 1" washer and
cotter pin that are provided to attach the tension
link to the hitch as shown in Figure AsmP-R-
0126.
GX-130 04/23 Assembly Section 3-8
© 2023 Alamo Group Inc.