MAINTENANCE
NUTS AND BOLTS
Check all nuts and bolts for tightness after the first 8 hours of operation then weekly. Check the condition of
cotter pins, roll pins and other fasteners weekly and replace if necessary.
Bolt Grades and Torque
When replacing damaged bolts use only plated Grade 5 bolts unless otherwise specified. Use only bolts of the
correct length (Refer to the "Parts" Manual). Do not replace locknuts with nuts and lockwashers. Use only
original equipment locknuts.
Recommended Torque in foot pounds for SAE Grade 5 bolts, based on dry assembly:
GX-130 04/23
Maintenance Section 5-20
© 2023 Alamo Group Inc.