Transporting The Tractor And Implement - Schulte GX-130 Operator's Manual

Table of Contents

13. TRANSPORTING THE TRACTOR AND IMPLEMENT

Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind

when you finish working in an area. Therefore, the operator must employ good judgment and safe operation

practices when transporting the tractor and implement between locations. By using good judgment and

following safe transport procedures, the possibility of accidents while moving between locations can be

substantially minimized. OPS-U- 0017str

Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in death or serious injury.

Before transporting the tractor and mower, idle

the tractor engine, disengage the PTO and wait

for all mower moving parts to come to a complete

stop.

Once all mower parts are completely

stopped, raise the mower to transport height.

NOTE: When raising the mower, maintain 1"

clearance between the driveline and mower deck.

If additional mower deck height is needed for safe

transport, disconnect the driveline from the tractor

and secure its end to the mower deck. The

mower can then be raised to the maximum lift

height. OPS-R-0033 str

If the tractor's hydraulic pump is not independent

of the tractor PTO, or if the tractor PTO has to be

run to have hydraulic power, disconnect the

mower driveline from the tractor PTO output

shaft. Secure the driveline to the mower deck to

prevent driveline damage or loss during transport.

OPS-R-0034 str

GX-130 04/23

OPERATION

Operation Section 4-44

(SG-10)str

Table of Contents