Start/Stop - Texas A/S BCX 300 User Manual

Filling gasoline – No smoking!
Remove filler cap slowly. Place on a clean surface.
Carefully pour fuel mix into tank. Avoid spilling.
Replace and tighten filler cap immediately. Wipe up spilt fuel.
NB: Always switch engine off before filling. Never pour fuel into a machine which is running
or when engine is hot. Move machine at least 3 meters away from filling site before
starting engine. Allow engine to cool for at least 2 minutes before fuelling.
Fuelling (NO SMOKING)
-
1. Always mix and store fuel in an approved container.
2. Always mix fuel outdoors away from sparks or flames.
3. Choose an open space, switch off engine and allow to cool for at least 2
minutes before fuelling.
4. Slacken filler cap slowly to release pressure and avoid fuel brimming over
under cap.
5. Wipe any spilt fuel off machine. Move machine at least 3 meters away from
filling site before starting engine.

9. Start/Stop

Starting a cold engine.
Place trimmer on a solid, level surface.
Set switch to "Start" (figure 8,3).
Press pump 8-10 (under air filter) (figure 9,2).
Set choke (figure 9,1)
Activate safety switch (figure 8,2), and press throttle (figure 8,1). Lock handle with lock
mechanism (figure 8,4).
Pull starter cord until engine fires.
Set choke to run position (figure 9,1)
when engine is warm.
Starting a warm engine.
Set start switch to "Start" (figure 8,3).
Set choke (figure 9,1)
Pull starter cord until engine fires (figure 2,4).
Stopping engine
Release throttle (figure 8,1).
Set switch to "Stop" (figure 8,3).
Check oil level in air filter.
If necessary top up. - see item 10.
www.texas.dk
21