Switch From Bush Clearer To Trimmer - Texas A/S BCX 300 User Manual

NB: Keep trimmer head parts together.
Fitting blade – Figures 5, 6
4. Fit holder (7) into trimmer gear wheel (9), and bushings (5) to secure shaft.
5. Fit blade (6) and spacer (4) to shaft.
6. Fit washer and nut (2). Tighten securely anticlockwise.
Always ensure blade is secure. If in doubt, contact your nearest dealer.
Using the blade
Keep blade in dense grass or weeds when stopping engine until rotation has
-
ceased.
Always hold machine securely in both hands.
-
Do not use if screen is incorrectly fitted and in poor condition.
-
Always stop engine before removing any materials stuck in blade.
-
Never attempt to touch or stop blade whilst it is rotating.
-
A rotating blade can cause injury, as it will continue to rotate after the engine is
-
stopped or gas regulator activated. Always maintain control over the machine until
blade stops completely.
Always ensure blade is correctly fitted before use.
-
Always use a sharp blade. Replace damaged or worn blades.
-
Use original spare parts only.
-
Use blade for weeds, grass and the like only.
-
Kickback is a reaction which can occur when a rotating blade comes into contact
-
with something it cannot cut. This can cause the blade to stop for a moment
causing the machine to recoil from the object it hit. This reaction can be so violent
that control over the machine can be lost. Kickback can occur without warning if the
blade gets stuck, loses speed or is impaired. This is more likely in areas where it
can be hard to see the material to be cut.
Always ensure strap is properly adjusted.
-
Maintain a firm grip on both handles whilst blade is in use. Keep blade away from
-
body and under waist height.

6. Switch from bush clearer to trimmer

Remove blade – Figure 5,6.
1. Fit holder (7) into trimmer gear wheel (9), and bushings (5) to secure shaft.
2. Remove blade retaining nut (2).
3. Remove washer (3), spacer (4) and blade(6).
Fitting trimmer head – Figure 5,6
1. Fit holder (7) to trimmer head to secure to shaft
2. Fit trimmer head by turning anticlockwise.
3. Tighten trimmer securely before use.
NB: Keep blade parts together.
www.texas.dk
19