Rear View - Lenovo 7X19 Setup Manual

Table 7. Options available on the front operator panel (continued)
Actions

Rear view

This section contains information about the LEDs and connectors on the rear of the server.
The following illustrations show the connectors and LEDs on the rear of the server.
Figure 11. Rear view
Table 8. Components on the server rear view
PCIe slots (slot 1-2, 8-11)
1
PCIe riser-card (slot 3-5)
2
M.2 backplane (slot 6, internal)
3
Actions provides the following available actions, which come in effect by pressing and
holding on the select button for three seconds:
• Restore XCC default settings is displayed as following:
RESTORE XCC DEFAULTS?
HOLD v FOR 3s
• Restart XCC is displayed as following:
REQUEST XCC HARD RESET?
HOLD v FOR 3s
• Request XCC physical presence is displayed as following:
REQUEST XCC PHY. PRES.?
HOLD v FOR 3s
• Clear CMOS is displayed as following:
CLEAR CMOS?
HOLD v FOR 3s
Note: This action is only available when the system power is off.
• System reboot is displayed as following:
SYSTEM RESET BUTTOM?
HOLD v FOR 3s
System error LED (yellow)
10
Identification button
11
Identification LED (blue)
12
Chapter 2
.
Server components
21