Table of Contents
Advertisement
Figure 65. LOM adapter installation
Step 4.
Close the retention latch.
How to adjust the position of the retainer on the M.2 backplane
Use this information to adjust the position of the retainer on the M.2 backplane.
Before you adjust the position of the retainer on the M.2 backplane, complete the following steps:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To adjust the position of the retainer on the M.2 backplane, complete the following steps:
Step 1.
Locate the correct keyhole that the retainer should be installed into to accommodate the particular
size of the M.2 drive you wish to install.
Step 2.
Press both sides of the retainer and move it forward until it is in the large opening of the keyhole;
then, remove it from the backplane.
Step 3.
Insert the retainer into the correct keyhole and slide it backwards until the nubs are in the holes.
Figure 66. M.2 retainer adjustment
ThinkSystem SR850 Setup Guide
102
52).
"Safety" on page iii
and
"Installation
Advertisement
Table of Contents
