enphase IQ7 Installation And Operation Manual page 9

NOTES:
9
IQ7+/IQ7X/IQ7A Microinverters Installation and Operation Manual
When looping the IQ Cable, do not form loops smaller than 4.75" (12 cm) in
diameter.
Provide support for the IQ Cable every 1.8 m (6 feet).
If you need to remove a sealing cap, you must use the IQ Disconnect Tool.
When installing the IQ Cable and accessories, adhere to the following:
•
Do not expose the terminator cap or cable connections to directed,
pressurized liquid (water jets, and so on).
• Do not expose the terminator or cable to continuous immersion.
• Do not expose the terminator cap or cable connections to continuous
tension (for example, tension due to pulling or bending the cable near the
connection).
• Use only the connectors provided.
• Do not allow contamination or debris in the connectors.
• Use the terminator cap and cable connections only when all parts are
present and intact.
• Do not install or use in potentially explosive environments.
•
Do not allow the terminator to come into contact with an open flame.
• Fit the terminator cap using only the prescribed tools and in the
prescribed manner.
• Use the terminator to seal the conductor end of the IQ Cable; no other
method is allowed.
© 2023 Enphase Energy Inc. All rights reserved. August 2023
USM-00003-1.0