Table of Contents
Advertisement
1.
Turn fence upside down and loosen lock nuts
with a 10mm wrench through the slots (Figure
6-19. Note: A socket wrench can fit into the
slot, and will speed the process.
Figure 6-19
2.
Remove lock nuts.
3.
Turn fence on its side and pull side plate from
frame (Figure 6-20).
4.
Replacement side plates come with fasteners
already attached. With fence still on its side,
align new side plate so that the attached bolts
line up with the holes on the frame. See Figure
6-20. Mount the new side plate to the frame.
5.
Turn fence on its back and secure side plate
by
lightly
tightening
overtighten.
6.
Make any necessary adjustments to side plate
height according to preceding instructions.
Figure 6-20
7.0 Rail installation on a
non-Powermatic Saw
The following instructions are for installing the
Accu-Fence and Rail System on a table saw other
than a Powermatic model. Some drilling is
required.
all
nuts.
Do
not
13
7.1 Tools required for assembly
Open-end wrenches, 10mm and 13mm
Hex wrenches, 5mm and 6mm
Adjustable square
Rubber mallet (or hammer and block of wood)
Straight edge
Electric drill with 9mm (or 11/32") bit
7.2 Installing front rail
1.
Identify the front rail, which is 3" x 3" with
notches on one side.
2.
Place a mark 18" from left end of front rail
(Figure 7-1). This mark will be lined up with
saw blade.
Figure 7-1
3.
Lay a straight edge flush against right side of
saw blade, as shown in Figure 7-2, and place
notched side of front rail against saw table as
shown. Hold front rail to saw table with clamps.
Make sure the mark on front rail aligns with left
edge of straight edge (and thus in line with the
blade).
Figure 7-2
4.
The front rail must be parallel to table top in
order for the Accu-Fence system to function
properly. Place an adjustable square on the
table, as shown in Figure 7-3.
Advertisement
Table of Contents
