Table of Contents
Advertisement
tion to slide on to the screw so that the nut and washer
compress the guard's feet against the plate.
4.
When the splitter assembly is properly situated,
tighten the screws, (Figure 13, Item B and Figure 14,
Items A and C).
SAW BLADE INSTALLATION
Tools required
Arbor wrench
12mm wrench
12mm socket wrench with extension.
1.
Disconnect the machine from the power source.
2.
Raise the arbor to its highest point and remove
the arbor nut by turning it counterclockwise as shown
in Figure 15.
3.
Remove the flange and place the saw blade on
the arbor making sure the cutting edge of the teeth, at
the top of the blade, face toward the front of the
saw, as shown in Figure 16.
4.
Slide the flange on the arbor and start the nut on
the threads. Snug the nut against the flange using the
wrench while holding the saw blade with your thumb
and fingertips as shown in Figure 16.
5.
Lower the saw blade and wedge a block of wood
between the blade and the table to keep the blade
from moving. Tighten the blade securely with the arbor
wrench provided.
6.
See Aligning The Splitter To The Blade in
this manual to align the splitter with the saw blade.
CAUTION: Before operating the saw, the
!
splitter must be aligned with the blade to
help prevent kickback.
MOUNTING THE TABLE INSERT
Tools required
3mm hex wrench.
1.
Place the table insert in the saw blade opening.
With a straight edge, check to see if the insert is level
with the surface of the table as shown in Figure 17.
2.
If the insert is not level, correct it by using the
straight edge and turning the four 1/4-20 x 5/16 set
screws in or out until the insert is flush with the table.
FIGURE 14
FIGURE 15
FIGURE 16
13
Hide quick links:
Advertisement
Table of Contents
