Table of Contents
Advertisement
6.4.3 Installing wood table
The optional wood extension table (including
optional router table) sits flush against saw table
and along inside of rails. The Powermatic logo
should face outward. The extension table is not
bolted to the saw table; it is bolted only to the rails.
Extension table and saw table must be aligned
properly so the Accu-Fence will slide smoothly
from one to the other.
1.
Place extension table between rails and up
against saw table, leaving extension table
raised just slightly above saw table. Clamp
extension table to front and back rails as
shown in Figure 6-7. Clamping pressure
should be enough to secure table yet allow
minor adjustments.
Figure 6-7
2.
Use a rubber mallet (or hammer and flat block
of wood) to tap extension table up flush
against saw table (Figure 6-7). Then tap down
extension table at various points along its edge
where it meets saw table, until it is level with
saw table (Figure 6-8).
Note: Never use a steel-face hammer directly
against saw table or extension table.
Figure 6-8
3.
As one part of the edge becomes level with
table, tighten the clamp on that side. Then
move to the other side and repeat, until the full
length of the edge is level with saw table.
4.
Lay a straight edge across both extension
table and saw table to ensure proper leveling.
5.
When extension table is properly aligned, drill
holes into wood table using holes in rails as
guide. See Figure 6-9. (You may wish to drill
3/32" pilot holes first.) Drill 9mm (or 11/32")
holes into front edge and back edge of table
using holes in the rails as your guide.
6.4.4 Securing wood table to front rail
See Figure 6-10.
Insert flat head screws (A, Figure 6-10) through
front rail and wood extension table, and secure
with washers and hex nuts. Finger-tighten only at
this time.
6.4.5 Securing wood table to back rail
See Figure 6-11.
1.
Insert six socket hd cap screws (E, Figure 6-
11) and flat washers (F) through back rail and
wood
extension
washers and nuts. Finger-tighten only.
2.
Re-check table for alignment along front and
back
rails.
necessary.
3.
Tighten all screws and nuts.
10
Figure 6-9
Figure 6-10
table,
and
secure
Make
further
adjustments
with
if
Advertisement
Table of Contents
