Operator's Manual: Seed Titan
4.3.2 Engine Speed Setting:
ROTATING PART HAZARD
The engine speed must be adjusted with the
engine running. Use extreme caution when
working near rotating parts.
Every engine is set with a high idle of 3000 RPM.
Before using the seed tender, check the RPM.
1. Start the engine. Set the engine to high idle
(full throttle).
2. Use a tachometer to check the large drive
pulley speed. The pulley should turn 200
RPM at high engine speed.
3. Use a screwdriver to reset the high idle stop
screw if required to obtain the desired speed
4-6
2SE/4SE Box Seed Tender
™
Fig 60 - Engine speed setscrew
Fig 61 - Drive belt pulley inside guard
Revised 02.2021