Electrical; Electrical Requirements; Pairing The Remote And Receiver - ORTAL 98 Series Installation And Operation Manual

WARNING: Disconnect the power supply before servicing any electrical components.

Electrical Requirements

A duplex receptacle with two outlets (not included) must be installed in the location where the gas and electrical components will be
placed, which must be to the side or back of the fireplace within 36 inches of the pilot (see diagram in "Routing the Gas Line" section
on page 36). Electrical work should be performed by a qualified licensed electrician, per local code.
1 Duplex Receptacle (2 outlets)
NOTE: Any device that functions using the same radio frequency as the handset will be affected when remote-controlled
handset is in use.

Pairing the Remote and Receiver

To set up the remote-control device to operate the fireplace, follow the following guidelines to pair the remote and receiver unit on
the same radio frequency.
Press and hold the receiver's reset button until you hear two beeps. The first beep is short, and the second beep is long.
•
After the second beep, release the reset button.
Within the subsequent 20 seconds, press the following button depending on the mode of operation:
•
10-Button Handset: Press the

display confirming that the synchronization and data exchange are in process.
Puck Handset: Press and hold the

Wall Switch: Use the 10-button handset to synch with the receiver. Once the remote and receiver are paired, the

wall switch will function normally.
MyFire App: Use the 10-button handset to synch with the receiver. Once the remote and receiver are paired, the

App will function normally.
• You will hear two short beeps confirming the connection.
NOTES:
If you hear one long beep, this indicates the connection has failed or the wiring is incorrect.
The connection between remote and receiver only needs to be made once and is not required after changing the batteries

in the remote.

Electrical

Outlet Type
button. "CONN" and a running number from 1 to 8 will appear on the handset
–
button approximately 4 seconds.
Power Requirements
120V, 15 amp, 60Hz
39