Page 1
Homeowner’s Fireplace Operation Manual Applicable Model Series: Front Facing Series Corner (RS/LS) Series See Through Series Three Sided Series Peninsula Series Stand Alone Series Lyric Homeowner's Operation Manual: November 2019 (V2)
Young children should be carefully supervised when they It is essential that the fireplace, vent and complete venting are in the same room as the appliance. Toddlers, young are cleaned and inspected annually by a Lyric dealer. children and others may be susceptible to accidental...
Introduction Thank you for choosing Lyric by Ortal to transform your living space! As a leader in innovation, Ortal has been providing long-lasting, luxury gas fireplaces for over 30 years, showcasing captivating modern design and advanced technology with the upmost safety and efficiency in mind. With our mesmerizing flame and innovative heating solutions, your new fireplace is sure to be the star of the show.
Table of Contents Fireplace Safety Information and Warnings ....................1 Introduction ..............................2 Initial Operation and Flame Appearance ......................4 Initial Burning Period ..........................4 Flame Appearance ............................. 4 Automatic Turn Down ..........................4 Automatic Shut Off ............................ 4 Remote Control Options..........................4 10-Button Handset ............................
Low Battery Receiver: With low battery power in the receiver, the system will shut the fireplace off • completely. This will not happen if the power supply is interrupted. NOTE: If you have any questions or concerns about the operation of your Lyric fireplace, please contact an authorized Lyric dealer for assistance. Remote Control Options...
IMPORTANT NOTES: • Wiring of valve and receiver must be completed before starting ignition. Failure to do so could damage the electronics. • If operating the fireplace without an AC adapter, battery replacement is recommended at the beginning of each heating season. •...
Page 7
Turning the Fireplace On 1. Press button and button simultaneously until you hear continuous beeping and a blinking series of lines confirms the start sequence has begun; release buttons. 2. Main gas flows once pilot ignition is confirmed. 3. The Symax system automatically goes into Manual Mode after main burner ignition. NOTE: When pilot ignition is confirmed, motor turns automatically to maximum flame height.
Page 8
Designated Low Flame Setting 1. To go to designated low flame setting, double-click button. 2. LO is displayed. NOTE: Flame goes to high flame before going to low flame. Designated High Flame Setting 1. To go to designated high flame setting, double-click button.
Page 9
Setting the Time 1. Press buttons simultaneously. Day will flash on the display. 2. Press button to select a number to correspond with the day of the week. (1=Monday, 2=Tuesday, 3=Wednesday, 4=Thursday, 5=Friday, 6=Saturday, 7=Sunday) 3. Press buttons simultaneously. Hour will flash on the display. 4.
Page 10
Thermostatic Mode • The room temperature is measured and compared to the set temperature. The flame height is then automatically adjusted to achieve the set temperature. Thermostatic Mode: Turn On and Off 1. Press button. will appear in the display. Preset temperature will appear briefly, and then room temperature will appear.
Page 11
Program Mode • PROGRAM 1 and 2, each can be programmed to go ON and OFF at specific times at a set temperature. Program Mode: Turn On and Off 1. Press button. , 1 or 2, ON or OFF will appear on the display. OFF: 1.
Page 12
Program Mode: Temperature Setting 1. Press button and hold until flashes. ON and set temperature (setting in Thermostatic Mode) will appear on the display. 2. To continue, press button or wait. , OFF will appear on the display, and temperature will flash. 3.
Page 13
NOTE: Either continue to PROGRAM 2 and set on and off times or stop programming at this point and PROGRAM 2 remains deactivated. NOTE: PROGRAM 1 and 2 use the same on (Thermostatic) and off temperatures for ALL, SA:SU, and Daily Timer (1, 2, 3, 4, 5, 6, 7).
Page 14
AC adapter according to the myfire App setup diagram, and the app setup must be completed. NOTE: If you have any questions or concerns about the operation of your Lyric fireplace, please contact an authorized Lyric dealer for assistance.
Puck Handset Technical Information Control Option Radio Frequency Power Supply Replace batteries after 2 years or 2 x 1.5V AAA batteries 918.0 MHz Puck Handset when low battery indicator (quality alkaline recommended) (U.S. & Canada) appears on handset display IMPORTANT: For safety/communication purposes, Puck handset must be located within 26 feet of the receiver. NOTE: Any device that functions using the same radio frequency as the handset will be affected when handset is in use.
Designated High Flame Setting • To go to designated high flame setting, double-click + button. NOTE: If you have any questions or concerns about the operation of your Lyric fireplace, please contact an authorized Lyric dealer for assistance. Wall Switch Technical Information...
Flame Height Adjustment INCREASE: • To increase flame height, press and hold (up flame) button. DECREASE: • To decrease flame height, press and hold (down flame) button. • Holding the (down flame) button long enough sets the fireplace to pilot flame (Standby Mode).
LOGIN 1. Fill in your registration password. 2. Accept “Terms and Conditions”. 3. Touch the “Login” button. Kwik Connect If KWIK Connect is not available, skip to “Standard Setup” instructions below. CONNECT SMART DEVIDE TO MYFIRE WI-FI BOX 1. Touch the icon.
myfire Wi-Fi Box Technical Information Power Part Radio Frequency Wireless Communication Supply • WPA2 authentication myfire Connects to 2.4 GHz • AES 256-bit encryption security Wi-Fi Box Receiver • Compatible with IEEE 802.11 b/g/n Modes of Operation The myfire Wi-Fi Box communicates with a home network (Wi-Fi Router) over a wireless signal. 1.
5. Close the cover and return the receiver to its place. NOTE: If you have any questions or concerns about the operation of your Lyric fireplace, please contact an authorized Lyric dealer for assistance.
(For custom models, warranties may vary) THE WARRANTY The Ortal Ltd. and Ortal USA. Inc. Limited Warranty warrants your Lyric gas fireplace (“Product”) to be free from defects in materials and workmanship at the time of manufacture. After installation, if covered components manufactured by Ortal are found to be defective in materials or workmanship during the Limited Warranty period and while the Product remains at the site of the original installation, Ortal USA will, at its option, repair or replace the covered components.
Page 22
Product. Ortal USA is not responsible for: (a) damages caused by normal wear and tear, accident, riot, fire, flood, climate and weather corrosion or natural disaster; (b) damages caused by abuse, negligence, misuse, or unauthorized alteration or repair of the Product affecting its stability or performance (The Product must be subjected to normal use.
Page 23
Ortal USA’s negligence. Ortal USA has not made and does not make any representation or warranty of fitness for a particular use or purpose, and there is no implied condition of fitness for a particular use or purpose.
Need help?
Do you have a question about the Lyric and is the answer not in the manual?
Questions and answers