Star Micronics TSP200 User Manual page 16

4) Once the paper has passed through
the printer mechanism's paper exit,
pull the paper straight to correctly
position it.
5) Make sure that the paper is straight
with approximately 15-20 centimeters
exposed and lower back the head-up
cutter.
6) Take the edge of the paper and cut it
by pressing it up against the head.
Be careful not to cut yourself on the
edge of the auto cutter unit during
this step.
7) Close the auto cutter unit (unneces-
sary if an auto cutter unit is not
installed).
8) Close the cover, turn on the ON
LINE switch and make sure that the
ON LINE indicator turns on.
See "Chapter 6: Control Panel" for
details on the ON LINE indicator
and switch.
Caution
When using the auto loading func-
tion, part of the paper will be exposed
after loading. Be sure to pass this
length of the paper through the paper
exit of the printer cover before clos-
ing the cover.
When loading paper manually, make
sure that paper has passed through
the paper exit of the printer cover
after closing the cover and pressing
the FEED switch.
– 12 –