Appendix D: Peripheral Unit Drive Circuit - Star Micronics TSP200 User Manual

Appendix D: Peripheral Unit Drive Circuit

A drive circuit for driving peripheral units (such as cash drawers) is featured on
the main logic board of this printer. A modular connector for driving peripheral
units is featured on the output side on the drive circuit. When using this circuit,
connect the cable for the peripheral unit. (Cables must be prepared by the user.)
Use cables which meet the following specifications.
1. Use the modular plug as shown in Figure below.
2. Separate ground wire is required for Europe only.
3. If the printer is used in Europe, the Ferrite core should be attached to the cable,
as shown in Figure below.
CAUTION: DO NOT connect any other plug to the peripheral unit connector.
Modular plug MOLEX 90075-0007,
AMP641337 or JAPAN BURNDY B-66-4
Separate ground wire and noise filter are required for Europe.
Cable specifications for peripheral unit.
– 130 –
Shield
Wire lead
Separated ground wire
connected to shield (Europe only).
Ferrite core
1 turn
Ground wire