Sun Microsystems StorEdge A7000 Manual page 26

Variable
gie
iel
mask
ists
ipend
opend
over
master
local
timer0
timer1
The program then displays the following message and starts testing the clock:
Start of testing for Clock n
Variable
n
After the clock is tested, the program redisplays the TS80 interrupt registers and
displays the following message:
Clock n done
Variable
n
The test then displays the ...PASSED or ...FAILED milestone message.
4-6 Sun StorEdge A7000 External Interrupt and Clock Cable Diagnostic Reference Manual • October 1998
Description
Specifies the contents of the Global Interrupt Enable register.
Specifies the contents of the Interrupt on Edge not Level register.
Specifies the contents of the Symmetric Interrupt Unmask register.
Specifies the contents of the Interrupt Status register.
Specifies the contents of the Symmetric Interrupt Pending register.
Specifies the contents of the Symmetric Overrun Pending register.
Specifies the contents of the Interrupt Overrun register.
Specifies the contents of the Master Status and Control register.
Specifies the contents of the Local Timer Status and Control register.
Specifies the contents of the Local Timer 0 Read register.
Specifies the contents of the Local Timer l Read register.
Description
Specifies the external clock under test.
Description
Specifies the external clock under test.