Sun Microsystems StorEdge A7000 Manual page 18

If you entered Y, go to Step 6. If you entered N, the program displays:
Which external interrupt cable do you wish
to test? = 0 ;[cr,?,^,(0-7)]?
Enter the number of the external interrupt cable to be tested or enter one of the
standard responses. Valid cable numbers are 0 through 7.
6. The program displays:
Do you wish to check for all external
clock cables? = Yes ;[cr,?,^,Y,N]?
Enter one of the following or a standard response:
Response
Y
N
If you entered Y, program initialization is complete. If you entered N, the program
displays:
Which external clock cable do you wish
to test? = 0 ;[cr,?,^,(0-1)]?
Enter the number of the external clock cable to be tested or enter one of the
standard responses. Valid cable numbers are 0 and 1.
Note – To run tests in interactive mode, use the a, e, or t option from the
Interactive Mode Options Menu to select the desired tests. Then use the
start test execution. The interactive mode options are described in the Sun StorEdge
A7000 Diagnostics Reference Manual.
If an invalid selection is entered at an initialization prompt, the diagnostic displays
an Invalid Response message and redisplays the prompt.
2-4 Sun StorEdge A7000 External Interrupt and Clock Cable Diagnostic Reference Manual • October 1998
Description
Enables testing all external clock cables.
Enables testing a single external clock cable.
option to
r