Axis P5676-LE User Manual page 65

AXIS P5676-LE PTZ Camera
Specifications
Multicable connectors
1
Camera multiconnector
2
I/O terminal block
3 Audio terminal block
4
Power connector
The multicable provides the following connectors:
Power connector - 2-pin terminal block used for power input. The polarity of the cables does not matter. Use a Safety Extra
Low Voltage (SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or a rated output
current limited to ≤5 A.
Audio connector - 4–pin terminal block used for audio in and audio line out. This can be connected to a public address (PA) system
or an active speaker with a built-in amplifier.
Function
Audio In
Audio Line Out
GND
I/O terminal connector - Use with external devices in combination with, for example, tampering alarms, motion detection, event
triggering, and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the
interface to:
• Digital output — For connecting external devices such as relays and LEDs. Connected devices can be activated by
the VAPIX® Application Programming Interface or from the device's web interface.
• Digital input — For connecting external devices that can toggle between an open and closed circuit, for example
PIR detectors, door/window contacts, and glass break detectors.
Multicable overview
Pin Notes
1
Balanced or unbalanced input for a mono microphone or line signal
3
Can be connected to a public address (PA) system or an active speaker with a built-in
amplifier
2, 4
Ground
65