Axis P5676-LE User Manual page 13

AXIS P5676-LE PTZ Camera
Configure your device
3. Select Video format H.264.
4. Go to Video > Stream > General and increase Compression.
5. Go to Video > Stream > Zipstream and do one or more of the following:
Note
The Zipstream settings are used for both H.264 and H.265.
- Select the Zipstream Strength that you want to use.
- Turn on Optimize for storage. This can only be used if the VMS supports B-frames.
- Turn on Dynamic FPS.
- Turn on Dynamic GOP and set a high Upper limit GOP length value.
Note
Most web browsers don't support H.265 decoding and because of this the device doesn't support it in its web interface.
Instead you can use a video management system or application that supports H.265 decoding.
Set up network storage
To store recordings on the network, you need to set up your network storage.
1. Go to System > Storage.
2. Click
3. Type the IP address of the host server.
4. Type the name of the shared location on the host server under Network share.
5. Type the username and password.
6. Select the SMB version or leave it on Auto.
7. Select Add share even if connection fails if you experience temporary connection issues, or if the share is not yet
configured.
8. Click Add.
Record and watch video
To record video you must first set up network storage, see , or have an SD card installed.
Record video
1. Go to the live view.
2. To start a recording, click Record. Click again to stop the recording.
Watch video
1. Click Storage > Go to recordings.
2. Select your recording in the list and it will play automatically.
Add network storage under Network storage.
13