Initial Assembly - Kalamazoo K54DB Use And Care Manual

Initial Assembly

Your grill does not require any major assembly, but some pieces are wrapped
individually to prevent shipping damage.
A. If not already attached, secure the gas hose to
brass supply fitting on the grill. The gas hose
connection is a flare fitting. No sealant is required.
Tighten with a wrench and check for leaks before
use.
B. Insert the CLEANOUT TRAY into the bottom of
the grill chassis, tilting over the roller bearings.
C. Place the CLEANOUT PANS into the cleanout
tray.
WARNING:
Never open the cleanout tray or
touch the cleanout pans when the grill is hot.
D. Position the HEAT DIFFUSERS above the main
burners inside the grill.
FIGURE 8
28
E. Place the COOKING GRATES into the grill above
the heat diffusers.
F.
Position the WARMING RACK at the desired level
on the WARMING RACK SUPPORTS G.
H. See page 33 for rotisserie rod installation
instructions.
I.
If not already attached, mount the CONTROL
KNOBS onto the valve stems.
J. For K42DT and K54DT Freestanding Grills only,
Heavy duty LEVELING CASTERS can be used
level the grill once it is positioned in its final
location.
For K42DT and K54DT Freestanding Grills only, raise
the foot when moving the grill. Once in position
lower the feet as needed to level the grill. Use a 7/8"
crescent wrench to turn the adjustment knob if you
need extra leverage.
KalamazooGourmet.com