Grill Controls - Kalamazoo K54DB Use And Care Manual

Grill Controls

Each grill control knob corresponds to an individual burner control. The symbol to the right
of the knob indicates which type of burner and the burner position that knob controls. The
electronic ignition system works with one burner at a time. Activate the electronic ignition
point by pressing inward on the control knob.
FIGURE 16
Main Burner Controls: Controls the flame
on the main burners. Grills have three
or four main burners depending on the
model.
Rotisserie Burner Control(s): Controls
the flame on the rotisserie burner(s).
Grills have one or two rotisserie burners
depending upon the model.
Rotisserie Motor On/Off Switch:
Activates the rotisserie motor. Requires
grill to be plugged into an outdoor GFI
outlet (120V).
Lights On/Off Switch: Activates the
interior task lighting.
Control Bezel Lights
A flashing white light indicates the hot surface
ƒ
ignition is active and the valve stem is pressed
inward. The flash interval timing is one second to
aid in following the proper lighting procedure as
described on page 39.
ƒ A flashing blue light indicates the valve stem is
pressed inward, but the ignition system has timed
out and turned off.
36
FIGURE 17
A steady orange glow indicates the system senses
ƒ
heat at the burner.
ƒ A steady blue glow is shown when the system is
booting up after being connected to power.
OFF POSITION
'0' indicates the valve is in
the fully closed position.
See "Lighting Your Grill"
on page 39.
HIGH/START POSITION
'1' indicates the valve is
in the fully open position.
Push in on the knob to
turn it counter-clockwise
from the OFF position to
HIGH/START.
LOW POSITION
Without pushing in on
the knob, turn counter
clockwise for the range of
burner control between
HIGH and LOW.
KalamazooGourmet.com