Installing The Power Switch (For Ce) - JUKI DLM-5400NDD-7 Instruction Manual

3. Installing the power switch (for CE)

WARNING :
1. Be sure to attach the ground wire (green/yellow) to the specified location (on the ground side).
2. Take care not to allow terminals to come in contact with each other.
3. When closing the power switch cover, take care not to allow the cord to be caught under it.
❹
❷
1ø 220V-240V
Blue
❷
Green/
Yellow
Brown
❶
Blue
Green/
Yellow
❸
Brown
– 5 –
Do not insert the power plug into the plug
receptacle.
1) Remove screw ❶ on the side face of the power
switch cover to open the power switch cover.
2) Pass AC input cord ❷(40145128),
❸(M6102461DAA) through the rear face of the
power switch. Bundle the cord with cable clip
band ❹ to secure it.
3) Securely fix the terminals of the AC input cord
❷(40145128), ❸(M6102461DAA) by tightening
the screws at the specified locations.
4) Close the power switch cover. Tighten screw ❶
on the side face of the power switch cover.