Table of Contents
Advertisement
⑭ Function of stop immediately after the reverse feed stitching at the start of sewing (Function set-
ting No. 60)
This function temporarily stops the sewing machine even when keeping depressing the front part of the
pedal at the time of completion of process of reverse feed stitching at the start of sewing.
It is used when sewing a short length by reverse feed stitching at the start of sewing.
0 : Not provided with the function of temporary stop of the sewing machine immediately
n.
6
0
after the reverse feed stitching at the start of sewing
1 : Provided with the function of temporary stop of the sewing machine immediately after
the reverse feed stitching at the start of sewing
⑮ Function of soft-down of presser foot (with AK device only) (Function setting No. 70 and 49)
This function can softly lower the presser foot.
This function can be used when it is necessary to decrease contact noise, cloth defect, or slippage of cloth
at the time of lowering the presser foot.
Note : Change the time of function setting No. 49 together at the time of selecting the function of soft-
down since the sufficient effect cannot be obtained unless the time of function setting No. 49
is set longer when lowering the presser foot by depressing the pedal.
Setting range : 0 to 500 ms <10 ms/Step>
n.
4
9
0 : Function of soft-down of presser foot is not operative. (Presser foot is rapidly lowered.)
n.
7
0
1 : Selection of function of soft-down of presser foot
⑯ Function of reducing speed of reverse feed stitching at the start of sewing (Function setting No. 92)
Function to reduce speed at the time of completion of reverse feed stitching at the start of sewing :
Normal use depending on the pedal condition (Speed is accelerated to the highest without a break.) This
function is used when temporary stop is used properly. (Cuff and cuff attaching)
0 : Speed is not reduced.
n.
9
2
1 : Speed is reduced.
⑰ Retry function (Function setting No. 73)
When the retry function is used, if the sewing material is thick and not pierced with needle, this function
makes the needle pierce in the material with ease.
0 : Re-try function is not provided.
n.
7
3
1 to 10 : Re-try function is provided. (Needle-bar returning force before re-trying: 1 (small) -
⑱ Presser foot lifting solenoid suction time setting (Function setting No. 84)
Suction time of presser foot lifting solenoid can be changed. When heating is great, it is effective to lessen
the value.
(Caution) When the value is excessively small, malfunction will be caused. So, be careful when chang-
ing the value.
Setting range : 50 to 500ms <10/ms>
n.
8
4
Stop the sewing machine
temporarily to change
direction of sewing products.
Temporary stop
10 (large))
Sew without stopping
without a break.
– 48 –
Advertisement
Table of Contents
