NEC UNIVERGE SV9100 System Maintenance Manual page 50

Issue 1.0

3 - 12
* PORT STATUS (0401 --> 000f)*
PORT(PHYS) STATUS
0401h(0001h) : IDLE( 0h) 0000h 0000h
0402h(0101h) : IDLE( 0h) 0000h 0000h
----h(----h) : (----h) ----h ----h no station port is assigned
----h(----h) : (----h) ----h ----h no station port is assigned
----h(----h) : (----h) ----h ----h no station port is assigned
----h(----h) : (----h) ----h ----h no station port is assigned
----h(----h) : (----h) ----h ----h no station port is assigned
----h(----h) : (----h) ----h ----h no station port is assigned
0009h(0002h) : IDLE( 0h) 0000h 0000h
000ah(0102h) : IDLE( 0h) 0000h 0000h
000bh(0202h) : IDLE( 0h) 0000h 0000h
000ch(0302h) : IDLE( 0h) 0000h 0000h
000dh(0402h) : IDLE( 0h) 0000h 0000h
000eh(0502h) : IDLE( 0h) 0000h 0000h
000fh(0602h) : IDLE( 0h) 0000h 0000h
To display the status of trunk ports 1 through to 10:

status trk 01 0a
Slot
Enter Function
slot List the slot commands
available.
To display the information related to the Blade installed into a slot:

slot info nn
Where nn is the slot number 01 to 24 in hexadecimal
(example – an ESIU in slot 1 will show the following):
slot info 01
Slot information)
Slot ID : 1
Status : RUNNING
Logical unit ID : ESIU
Dump down message : Disable
Number of Tx errors : 1
Slot started delay : 2.83sec.
Common unit driver information)
Slot ID : 1
CALL HOLD
DIM Output
SLOT RX
SLOT TX
SLOT TXB
SLOT TXC
SLOT TXK
SLOT TXS
SLOT RESET
SLOT INFO
SLOT DUMP
SLOT KEEPALIVE
SLOT IF
SLOT WATCHSUBME(only PRI) watch SUBME
UNIVERGE SV9100
Rx simulation
Tx a packet (DSP,64K)
Tx a packet (128K)
Tx a packet (LKTS C/0)
Tx a packet (LKTS KTEL)
Tx a packet (LKTS STA)
Reset unit/slot
Slot/Unit info
Dump Tx message
Keep alive control
Slot interface