3. If equipped with factory Bluetooth: You are required to transfer wires
from contact carrier on factory GREEN plug to contact carrier
on AIH-RNS --see Fig. 3 OR purchase our
require this step.
To remove/release wires from carrier simply press pin locking tab /
and pull from contact carrier as seen in Fig. 4
AIH-RNSB
which does not
Fig. 3
Fig. 4
Warning: Prior to re-installing pins to contact carrier; the locking
tabs must be bent upwards so to lock in place after reinsertion.
4. Insert included amp remote turn-on wire (Blue) to slot 13 on factory black
connector (See Fig. 5)
Slot 13 is usually empty in non-BOSE applications. In BOSE application (or if
13 is already in use, simply splice or tap amp remote turn-on wire (BLUE)
to existing wire (usually white) (See Fig. 5).
5. Connect RCA patch cords (sold separately) to Front (Short) and Rear
(Long) terminals.
6. Route remote wire and RCA patch cords to amplifier location and proceed
with install according to amplifier install guide.
Fig. 5