Table of Contents
Advertisement
With the help of the following guide minor faults in the performance of the ma-
chine, some of which may result from incorrect operation, can be remedied with-
out contacting the Service Department.
This guide may help you to find the reason for the fault, and how to correct it.
Some of the messages in the display are more than one line long. Touch the or
sensor button to read them in full.
The display indicates messages or faults
Message
lights up after
000
switching on.
End/Cooling down
Clean plinth filter.
lights up
See
at the end of a
program.
Frequently Asked Questions
Possible cause and solution
The PIN code is activated.
Enter the code and confirm the entry. Deactivate
the PIN code if you do not wish this message to
appear in the display the next time the machine is
switched on.
The laundry will be cooled down at the end of the
program.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
The tumble dryer is not working correctly or econom-
ically. Possible causes could be clogging caused by
lint or detergent residue.
Please see "Cleaning and care" for notes on clean-
ing.
Clean the lint filters.
Also check the plinth filter and clean it if neces-
sary.
To switch off the message: press
You can influence when the
message lights up.
To do this, follow the instructions in "Settings –
Airway indicator".
OK
.
Clean plinth filter. See
57
Advertisement
Chapters
Table of Contents
