Table of Contents
Advertisement
Frequently Asked Questions
With the help of the following guide minor faults in the performance of the
machine, some of which may result from incorrect operation, can be remedied
without contacting the Service Department.
This guide may help you to find the reason for the fault, and how to correct it.
Indicator lights or information on the time display
Problem
The indicator light
comes on after a pro-
gram has been can-
celled and a signal
sounds.
The indicator light
comes on at the end of
the program.
lights up.
Bars flash on the dis-
play at the end of a pro-
gram: .........
46
Possible cause and solution
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
See "Cleaning and care".
To switch the indicator light off:
Open and close the door (with the dryer switched
on).
There is a build-up of lint in the airways.
Clean the lint filters.
Clean the plinth filter.
See "Cleaning and care".
To switch the indicator light off:
Open and close the door (with the dryer switched
on).
You can influence when the indicator light comes
on: See "Programmable functions", " Airway
indicator".
The program selector has been moved.
Select the original program. The time left will
appear on the display again.
The program has finished but the laundry has not yet
cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Advertisement
Table of Contents
