Operations Manual for the T 1565 C Condenser Dryer In order to protect yourself and avoid damage to your machine, it is absolutely necessary to read the operating instructions prior to installation and operation. M.-Nr. 03 719 520...
Contents Guide to the machine..........3 IMPORTANT SAFETY INSTRUCTIONS .
Supply cable with plug Condensed water container Drum door Control panel Drain hose for condensed water Four height-adjustable legs Guide to the machine...
Guide to the machine Pushbuttons – Door This button is used to open the door (does not stay pushed in). – jON / kOFF When the machine is turned on, the “On” indicator will light up if the door is closed.
WARNING - To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the follow- ing: 1. For your own safety and for the pro- tection of your machine read these operating instructions carefully be- fore using your dryer for the first time.
Residues from these products block- up (clog) the lint filter causing prema- ture failure of the dryer. Miele dryers are designed to dry laundry without static cling. How- ever, should fabric softener be re- quired, use liquid fabric softener in the wash cycle.
Disposal of the packing ma- terial. The transport and protective packing is mostly manufactured from the following recycled or re-useable materials: – corrugated paper/cardboard – polystyrene - CFC-free – polyethylene foil (transparent) – untreated wood – fiber board Please check local environmental regu- lations before disposing of packing ma- terials and discarding the appliance.
OPERATING INSTRUCTIONS Loading the machine WARNING - To reduce the risk of fire, electric shock, or injury to persons, read the IMPORT- ANT SAFETY INSTRUCTIONS before operating this appliance. Load the laundry loosely into the drum. Duvet covers and pillowcases should be fastened before drying in order to prevent small items from roll- ing inside of them.
The surface of the fabric may other- wise tend to become “rough”. Miele dryers have been designed to dry laundry free of static cling, without the use of dryer softener sheets or simi- lar products. The dryer continuously...
Program selection Functional description An electronic sensor system monitors the moisture content of the laundry. Once the required degree of dryness is reached, cold air then enters the drum to cool the laundry. The drying program is then terminated. Function of the pushbuttons –...
To select a program A program can only be selected when the machine is turned on. Set the desired program by turning the program selector either clock- wise or counterclockwise. Press the “Start” button. The program status will be stored for 30 minutes in the event of a power failure.
Programs COTTONS Extra dry Normal Normal- * Hand iron rr * Machine iron * These are the programs that should be tested according to the EN 61121/A11 Standard. Type of laundry/fabric Multi-layer fabrics, mixed load of cotton fabrics, e.g.jeans, towels, sweatsuits.
PERMANENT PRESS Normal + Normal * Hand iron * This is the program that should be tested according to the EN 61121/A11 Standard. TIMED DRYING warm cool Type of laundry/fabric Permanent press items made of synthetic or blended fabrics, e.g. pullovers, dresses, pants, etc., which are not dried adequately in the...
USER MAINTENANCE INSTRUCTIONS Emptying the condensed water container Depending on your type of installation, the condensed water will either be pumped to a drain, or collected in the condensed water container, located in the upper left corner of the machine. The container should be emptied after each drying program.
Cleaning the lint filters The lint is collected by the lint filter in the door. Clean the filter after every program. Grip the filter by the recessed handle and pull up to remove. Any remaining lint in the hollow part of the door can be removed through the gap at the bottom.
Cleaning and care Cleaning the heat exchanger The heat exchanger should be cleaned once or twice a year. Open the door. Turn the lever so that it is vertical. Remove the cover. Turn both levers on the heat ex- changer so that they are vertical.
Pull out the heat exchanger. Clean the heat exchanger: – at both ends (front and back). Cleaning and care – and along the two long sides. Stand the heat exchanger lengthwise on a towel until it dries. Replace the heat exchanger in the reverse order.
“finish”. – Turn the machine off and then on again. – Select a program. – Press the “Start” button. If the indicator lamp starts flashing again, this indicates a fault in the machine. Please contact the Miele Service Dept.
– Turn on the machine again. – Reselect the terminated program. – Press the “Start” button. If the drum door opens again, the Miele Service Dept. should be contacted. These two seals may occasionally cause condensed water to form on the door.
This is a temperature-resistant bulb and should only be ordered from your Miele Service Dept. To open the door in the event of a power failure Pull forward on the un-hinged side of...
In the event of problems which cannot be solved, please contact: – Your Miele Dealer – The nearest Miele Service Depart- ment (see back cover for the adress). When contacting the Service Depart- ment, please quote the Model and Se-...
14-30 R, 4 fuses, box and plug cord, which allows you to use that single dryer wall receptacle to supply power to a Miele washer and Miele dryer. Both machines may operate at the same time because each uses maximum about 15 A current.
The tumble dryer can also be placed on top of a Miele washing machine for a stacked installation. An appropriate stacking kit* to match your washing ma- chine is required.
Installation Connecting to an external drain The condensed water can be drained directly if the machine is installed near a sink or drain outlet. The machine is equipped with a non-re- turn valve as standard to prevent water from flowing back into the machine (eg. if the machine is connected to a siphon).
Close the water inlet port above the condensed water container with the bottom part of the rubber plug. The plug must face towards the interior of the machine so that the con- densed water container can easily be inserted. Attach the elbow to the hose and se- cure it to the sink or drain pipe.
(*EN 61121/A11). Different types of fabrics, load size and residual moisture after spinning may effect the specified values. *These values apply if the laundry is spun in a Miele washing machine before drying. Final spin speed in washer*...
Height......Height with lid removed ... . Width .
All rights reserved/002 4503 This paper is made from 100% chlorine-free bleached cellulose and therefore protects the environment.