Table of Contents
Advertisement
Frequently asked questions
Many malfunctions and faults that can occur in daily operation can be easily reme-
died. You can save time and money in many cases, as you do not need to contact
Miele Customer Service.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.
The display indicates messages or faults
Message
000
lights up after
switching on.
Finish/Cooling Down
Fault F. If restart
fails, contact Service
lights up after a
program has
been canceled.
Fill condensate con-
tainer with water
Please open and
close the door
58
Possible cause and solution
The PIN code is activated.
Enter the code and confirm the entry. Deactivate
the PIN code if you do not wish this message to
appear in the display the next time the machine is
switched on.
The laundry will be cooled down at the end of the
program.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program terminates again with the same fault
message, then there is a fault. Contact Miele Cus-
tomer Service.
Water is taken from the condensed-water container
when the
SoftSteam
densed-water container must be filled with water to
at least the –min– marker.
Fill the condensed-water container as described
under "Condensed-water container".
To switch off the message: press
This it to remind you to load the laundry when the
SoftSteam
program is selected.
Load the laundry in the drum.
program is being used. The con-
OK
.
Advertisement
Table of Contents
