Frequently Asked Questions; Check And Fault Messages In The Display - Miele PT 7135 C Vario Operating And Installation Instructions

Frequently asked questions

With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous.

Check and fault messages in the display

Problem
Adjust the load
1
The drum is empty or
the laundry is too dry.
Technical fault
;
If restart is unsuccessful,
call Service.
A fault number (e.g.
F43) might also be
displayed.
Power failure
:
program stopped
Press OK button
28
Possible cause
This is not a fault.
In some programs, if the
drum has been
overloaded or
underloaded, the
program will be
cancelled. This can also
happen if the items are
already dry.
A program cannot be
started while there is a
fault message in the
display.
The dryer was switched
off during a program or
there has been a power
outage.
Remedy
Use the Hot air program
(timed drying) to dry
individual items.
To delete the message:
– Open the door.
– Make a note of what
is shown in the
display.
– Try to start the
program again.
– Press the OK button
after switching the
dryer back on and
start the program
again.