Sound Board And Speaker Replacement - Dimplex 6911540100 Service Manual

Replacement Part Procedures

Sound Board and Speaker Replacement

Tools Required: Philips Screwdriver
Side cutters (for sound board replacement)
1. Follow the instructions for preparing for service. (Page 11)
2. Remove the 7 screws that secure the electronics panel (right panel). Carefully lower the electronics panel. (Figure 8)
!
NOTE: The electronics panel is supported by hooks in the back.
3. To replace the speaker:
- Remove the 4 screws that secure the speaker and unplug it from the board.
- Secure the new speaker and plug it in.
4. To replace the sound board:
- Clip the standoffs using side cutters.
- Unplug the connections from the defective sound board.
- Secure the new board using the provided standoffs.
- Plug in the connections on the new sound board.
5. Secure the electronic panel using the 7 screws previously removed.
6. Reinstall the back panel, LED holder (if applicable), media bed, and media.
Figure 11
Sound Board
Speaker
17