Main Control Board Replacement; Led Power Distributor Replacement; Power Supply Replacement - Dimplex XLF50 Service Manual

middle, along the top of the opening, ensuring that
neither the bracket nor the partially reflective glass falls
out of the unit. (Figure 5)
7. Gently lift the partially reflective glass out of the unit
and set it aside in a safe place.
CAUTION: Partially Reflective Glass is not tempered.
Do not bump or drop the Partially Reflective Glass to avoid
breakage and personal injury.
8. Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.

Main Control Board Replacement

WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. Locate the main control board. (Figure 6)
2. Transfer the connections from the old board to the new
board.
3. Remove the board, by removing the screw on each
corner.
4. Install the new board onto the unit.
5. Ensure that all wires are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.

LED Power Distributor Replacement

(Only XLF74 & 100)
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. Locate the power distributor. (Figure 6)
2. Transfer the connections from the old board to the new
board.
3. Remove the board, by removing the screw on each
end.
4. Install the new board onto the unit.
5. Ensure that all wires are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
Figure 6
XLF50/XLF60
Capacitive Controls
XLF74/100
and Display
Power Supply
LED Power
Distributor

Power Supply Replacement

WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. Locate the power supply. (Figure 6)
Main Control
Board
Flame Panel
Flicker Motor
13