Switch Board Replacement; Terminal Block Replacement - Dimplex CDFI1000P Service Manual

Switch Board Replacement

Tools Required: Phillips head screwdriver
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or
damage to persons.
!
NOTE: Ensure that all of the components that contain
water have been emptied and source water has been
turned off before performing any maintenance.
1. Disconnect and remove the media tray or log set from
the unit and put them in a safe place.
2. On the side the replacement is required, remove the
securing screws and metal wire cover.
3. Remove the 4 screws and the electronics cover from
the unit. (Figure 4)
!
NOTE: Use caution when removing the electronics
cover, to prevent strain on the connector wire attached
to it.
4. Locate the switch board to be replaced.
5. Gently lift the switch board off of the mounting stands.
6. Disconnect the wire connection from the back of the
board.
7. Attach the wire connection to the new board and place
on the mounting stands.
8. Re-assemble the remainder of the cassette in reverse
order from the instructions above.
Figure 4
LED Light Assembly
Electronics Cover
Fan
8

Terminal Block Replacement

Tools Required: Phillips head screwdriver
!
1. Disconnect and remove the media tray or log set from
2. On the secondary side remove the securing screws
3. Remove the 4 screws and the electronics cover from
!
4. Locate the terminal block to be replaced.
5. Disconnect the wire connections from the original block
6. Replace the terminal block in the original position - the
7. Re-assemble the remainder of the cassette in reverse
Switch Board
Terminal Block
Main Control Board
Power Supply
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or
damage to persons.
NOTE: Ensure that all of the components that contain
water have been emptied and source water has been
turned off before performing any maintenance.
the unit and put them in a safe place.
and metal wire cover.
the unit. (Figure 4)
NOTE: Use caution when removing the electronics
cover, to prevent strain on the connector wire attached
to it.
and install it on the new block.
terminal block is located so that it sits on the moulded
pins on the surface below.
order from the instructions above.
Electronic Choke
www.dimplex.com