Module Fused Wire Harness Replacement - Dimplex 6911540100 Service Manual

Replacement Part Procedures

Module Fused Wire Harness Replacement

Tools Required: Phillips head screwdriver
1. Follow the Preparing for Service instructions. (Page 11)
2. Remove the access cover screw. (Figure 16)
3. Remove the 4 screws and the electronic cover from the unit. (Figure 16)
4. Remove the 2 screws securing the cable clamp. (Figure 18)
5. Holding the electronics assembly close to the ends of the LED light strip, gently lift the electronics assembly out of
its original position to expose the attached components. (Figure 18)
6. Locate the fused wire harness (brown wire from main switch to main control board with in line fuse).
7. Replace current wire harness with new wire harness.
!
NOTE: A flat head screwdriver can be used to gently pry between the end of the connector and the switch to release
the wires.
8. Replace all of the wiring to their original locations and reinsert the electronic assembly.
CAUTION: Ensure that the terminal block has not moved from its original location and all wires are contained under
the cover before reassembly.
9. Reinstall the electronics cover and access cover in their original position in the module and secure the 5 screws.
10. Re-assemble the remainder of the components in reverse order from the Preparing for Service instructions. (Page 11)
Figure 19
22
Wire harness
connection
www.dimplex.com