Module Heating Element Replacement - Dimplex 6911540100 Service Manual

Replacement Part Procedures

Module Heating Element Replacement

Tools Required: Phillips head screwdriver
1. Follow the Preparing for Service instructions. (Page 11)
2. Remove the access cover screw. (Figure 16)
3. Remove the 4 screws and the electronic cover from the unit. (Figure 16)
4. Remove the 2 screws securing the cable clamp. (Figure 18)
5. Holding the electronics assembly close to the ends of the LED light strip, gently lift the electronics assembly out of
its original position to expose the attached components. (Figure 18)
6. Locate the 2 screws that secure the element assembly (element and brackets) to the unit and remove. (Figure 22)
7. Lift the element assembly out of the unit.
8. Disconnect the element from the main control board.
9. Remove the element from the mounting bracket and install the new element.
10. Attach the new element wire to the main control board.
11. Install and secure the element assembly into the module.
12. Place all of the wiring in their original locations, and reinsert the electronics assembly.
CAUTION: Ensure that the terminal block has not moved from its original location and all wires are contained under the
cover before reassembly.
13. Reinstall the electronics cover and access cover in their original position in the module and secure the 5 screws.
14. Re-assemble the remainder of the components in reverse order from the Preparing for Service instructions. (Page 11)
Figure 22
Cable Clamp
Main Board
Heating
Element
25