NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
OPERATION Figure 2 Figure 1 again. On Screen Display D & E . Thermostat Controls Adjusts the temperature set point to your individual require- The unit can be controlled by either the manual controls ments. Once the desired set temperature is reached the which are located on the upper right of the fireplace or the heater will turn off.
Compact Fireplace Surface Cleaning Use warm water only to clean painted surfaces of the Compact Fireplace. Do not use abrasive cleaners. Servicing Except for light bulb replacement and cleaning described above, an authorized service representative should perform any other servicing. www.dimplex.com...
SWITCHBOARD REPLACEMENT RELAY BOARD REPLACEMENT Tools Required: Phillips Head Screwdriver Tools Required: Phillips Head Screwdriver Flat Head Screwdriver Flat Head Screwdriver Needle Nose Pliers CAUTION: If unit was operating prior to servicing allow at least 10 minutes for lights, heating elements and top CAUTION: If unit was operating prior to servicing allow panel to cool off to avoid accidental burning of skin.
2. Remove the front glass and set aside in a safe place. 9. Properly orient and install the new assembly and con- 3. Remove the firebox from the back of the mantel by nect all of the wiring. www.dimplex.com...
FLICKER MOTOR & FLICKER ROD WARNING: Ensure wires do not come in contact with moving parts by securing wires in wiring tie wraps. REPLACEMENT 10. Reassemble in the reverse order as above. Tools Required: Phillips Head Screwdriver POWER CORD REPLACEMENT CAUTION: If unit was operating prior to servicing allow at least 10 minutes for lights, heating elements and top Tools Required: Phillips Head Screwdriver...
2. Remove the front glass and set aside in a safe place. 3. Remove the firebox from the back of the mantel by removing the retaining screws which secure the firebox Rear brackets to the mantel. Front Side Section Edge www.dimplex.com...
THERMISTOR REPLACEMENT Tools Required: Phillips Head Screwdriver CAUTION: If unit was operating prior to servicing allow at least 10 minutes for lights, heating elements and top panel to cool off to avoid accidental burning of skin. WARNING: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons.
Defective display/control board Replace the display/control board Log 3001350200RP Glass 3001350300RP Flame Shudder Defective Flicker Motor Replace Flicker Motor 2000220100RP Light leaking around the log Log set not positioned properly Check log set for proper fit set (if applicable) www.dimplex.com...
Page 13
PROBLEM CAUSE SOLUTION Heater Heater is not turning off Improper operation Refer to Operation Section Defective switchboard Replace switchboard 3001370100RP Defective thermistor Replace thermistor 3001380100RP Defective relay board Replace the relay board 3001360100RP Defective display/control board Replace the display/control board Log 3001350200RP Glass 3001350300RP Heater is not turning on, but...