Heater Assembly Replacement - Dimplex 6911540100 Service Manual

Replacement Part Procedures

Heater Assembly Replacement

Tools Required: Phillips-Head Screwdriver
1. Follow instructions for preparing for service. (Page 11)
2. Remove the 4 screws that secure the heater assembly panel (middle panel). Carefully lower the heater assembly.
(Figure 3)
!
NOTE: The heater assembly is supported by hooks in the back.
3. Unplug the socket connectors. (Figure 4)
4. Lift the heater assembly upward and pull it forward to unhook and remove the defective heater assembly.
5. Position the new heater assembly on the back hooks.
6. Plug in the socket connectors to connect the new heater assembly.
7. Tilt the new heater assembly up and secure it using the 4 screws previously removed.
8. Connect the LED wire(s), secure the LED holder(s), and reassemble any brackets removed previously.
Figure 3
Remove
supporting
brackets to
allow access.
Figure 4
12
Socket Connectors
www.dimplex.com