Table of Contents
Advertisement
HEATER ASSEMBLY REPLACEMENT
Required
1.
Follow steps 1-7 of "Preparing for Service" on page 5 of this manual before continuing.
2. Remove the two screws on the bottom of the fireplace that secure the heater assembly.
(Image 7)
3. Pull the heater assembly out of the fireplace.
4. Remove the two brackets and set them aside. (Image 8)
5. Disconnect the wires from the heater assembly, making note of their original locations. Snip
the zip ties as needed. For the connections that are made with wire nuts that cannot be
screwed off, cut them off using wire cutters.
TIP! Take a picture of the wires before disconnecting them! You can use this picture later
as a guide.
6. Connect the wires to the new heater assembly, using the picture you took before as a guide.
7. Strip the wires that were cut using wire strippers. Reconnect them in their original location
using the provided wire nuts, ensuring a strong enough connection that individual wires
cannot be pulled out from the wire nut. Use the provided zip ties to secure them out of the
way of other components.
8. Install the two brackets previously removed.
9. Properly orient and place the heater assembly and secure it using the two screws on the
bottom previously removed.
10. Install the fireplace as it was before.
11. Sit back and enjoy!
7
8
Recommended
8
Advertisement
Table of Contents
